Ryobi bt3000 repair manual

In order to use the instrument properly, please read this manual carefully before operation. Please keep it available for future use. Prior to the initial operation: Please check the Instrument and the accessories against the packing list when Home Extension Country Picing. Keyword Research: People who searched bt manual also searched.

Some earlier BTs are not. These instructions assume a stock. Stripped elevation and Helicoil installation. So I rushed out and bought my first table saw, than discovered this site and all the helpful information "like how to buy a BT saw.

What I didn't know was I had an elevation problem. The screw that runs from the 90 degree bevel gears up through the aluminum motor housing was badly worn.

Once I had the two parts out of the saw, the damage to the aluminum threads was worse. After a little help from others on this site, I choose to put in a helicoil.

The attachments show the pictures and how to View All. The SawdustZone Statistics. Topics: 60, Posts: , Members: 20, Active Members: Welcome to our newest member, tbyji2.

What's Going On. Most users ever online was 5, at AM on AdSense Footer. All rights reserved. Yes No. OK Cancel. Keep the blade guard down, the anti-kickback pawls down, and the riving knife in place over the blade. Page 8: Unpacking And Checking Contents Some until the missing parts are obtained and are installed models of the BT may also include a workstand with a correctly.

Call in the United States or separate parts list, owner's operating manual, and assembly in Canada for assistance if any parts instructions. Description Quan. Rip Scale Indicator Check with your nearest Ryobi dealer for more information. Use only accessories that are listed for use with this tool. Page Blades C. Page Assembly Each unit also includes two wrenches for easy blade removal or installation.

Install the sliding miter table assembly over the front and rear rails. See Figure Check that it slides easily on the rails. Push both front miter locking clamps down evenly on each side to secure.

Repeat for both rear miter locking clamps. Make sure the bevel locking lever is securely pushed to the left. Improper connection of the equipment can result in electric shock. Check with an electrician or service personnel if you are unsure about proper grounding. This can be controlled by holding the workpiece securely against the miter fence. See the Accessories Section on page It is held in place by two bolts and hex nuts at its base. The bolts are set in slots that permit front-to-back adjustment.

Kickback can cause serious injury. Page Featherboard Place the workpiece against the fence and over the saw blade area. Adjust the featherboard The featherboard is an excellent project for your BT Let the blade build up to full speed before moving the miter table to feed the workpiece into the blade. Use a push stick to move small pieces of wood past the 5. Attach the rip fence over the front and rear rails on the blade.

Page Operation Unplug the saw to avoid possible injury. Remove the three screws holding the throat plate in local Ryobi dealer or Ryobi Factory Service Center. Remove the throat plate. Unplug your saw. To maintain the table surfaces, fence, and rails, WARNING: periodically apply paste wax to them and buff to provide smooth functioning.